Reference health
Electrochemical characterization of coatings for local prevention of Candida infections on titanium-based biomaterials
71/71 checkable references clean · checked 2026-07-23
Every reference with a DOI in the deposited reference list resolved to a known work in Crossref or DataCite at the dated check, and none carried a retraction, withdrawal, or removal notice.
9 without a DOI — not checked. A reference deposited without a DOI is never matched by title or guessed at; it stays outside the checked set, and this line discloses that.
The 71 checked references that resolve
resolves10.1007/s11999-017-5396-4
Periprosthetic Joint Infection Is the Main Cause of Failure for Modern Knee Arthroplasty: An Analysis of 11,134 Knees
resolves10.1016/j.knee.2017.08.060
Knee instability as the primary cause of failure following Total Knee Arthroplasty (TKA): A systematic review on the patient, surgical and implant characteristics of revised TKA patients
resolves10.1007/s00264-010-1134-1
Failure following revision total knee arthroplasty: infection is the major cause
resolves10.1007/s11999-010-1251-6
Revision Hip Arthroplasty: Infection is the Most Common Cause of Failure
resolves10.1016/j.arth.2016.07.043
Patient-Reported Outcomes, Quality of Life, and Satisfaction Rates in Young Patients Aged 50 Years or Younger After Total Knee Arthroplasty
resolves10.1080/17453674.2017.1301009
Prosthetic joint infection—a devastating complication of hemiarthroplasty for hip fracture
resolves10.1016/j.arth.2015.02.011
Complication, Survival, and Reoperation Rates Following Girdlestone Resection Arthroplasty
resolves10.1111/imj.12174
<scp>E</scp>arly prosthetic hip joint infection treated with debridement, prosthesis retention and biofilm‐active antibiotics: functional outcomes, quality of life and complications
resolves10.1016/j.cmi.2016.05.004
Time trends in the aetiology of prosthetic joint infections: a multicentre cohort study
resolves10.1016/j.jiph.2015.12.014
Incidence and economic burden of prosthetic joint infections in a university hospital: A report from a middle-income country
resolves10.1016/j.jmii.2018.08.011
The incidence rate, trend and microbiological aetiology of prosthetic joint infection after total knee arthroplasty: A 13 years’ experience from a tertiary medical center in Taiwan
resolves10.1155/2019/4629503
Prosthetic Joint Infection Trends at a Dedicated Orthopaedics Specialty Hospital
resolves10.1016/j.jinf.2017.12.016
Analysis of postoperative and hematogenous prosthetic joint-infection microbiological patterns in a large cohort
resolves10.1002/jor.23068
Multi‐disciplinary antimicrobial strategies for improving orthopaedic implants to prevent prosthetic joint infections in hip and knee
resolves10.1016/j.arth.2017.03.030
Single-Stage Revision for Chronic Fungal Periprosthetic Joint Infection: An Average of 5 Years of Follow-Up
resolves10.1007/s11046-018-0286-1
Prosthetic Joint Infections Caused by Candida Species: A Systematic Review and a Case Series
resolves10.1080/23744235.2016.1219456
<i>Candida-</i>induced prosthetic joint infection. A literature review including 72 cases and a case report
resolves10.3892/etm.2016.3353
Risk factors and the clinical and surgical features of fungal prosthetic joint infections: A retrospective analysis of eight cases
resolves10.1016/j.jinf.2018.03.012
Candida periprosthetic joint infection: A rare and difficult-to-treat infection
resolves10.1016/j.arth.2015.10.015
Serum and Wound Vancomycin Levels After Intrawound Administration in Primary Total Joint Arthroplasty
resolves10.1902/annals.2003.8.1.79
Local Anti‐Infective Therapy: Pharmacological Agents. A Systematic Review
resolves10.2174/0929867321666140916121355
Current Developments in Antimicrobial Surface Coatings for Biomedical Applications
resolves10.1016/j.jconrel.2014.01.026
Metallic implant drug/device combinations for controlled drug release in orthopaedic applications
resolves10.1016/j.jconrel.2004.06.011
Incorporation of different antibiotics into carbonated hydroxyapatite coatings on titanium implants, release and antibiotic efficacy
resolves10.1016/j.ijpharm.2013.06.076
Biphasic mode of antibacterial action of aminoglycoside antibiotics-loaded elastic hydroxyapatite–glucan composite
resolves10.1016/j.biomaterials.2007.03.020
Influence of engineered titania nanotubular surfaces on bone cells
resolves10.1016/j.jconrel.2011.07.006
Sequential release kinetics of two (gentamicin and BMP-2) or three (gentamicin, IGF-I and BMP-2) substances from a one-component polymeric coating on implants
resolves10.1016/j.jconrel.2012.08.003
Multilayer, degradable coating as a carrier for the sustained release of antibiotics: Preparation and antimicrobial efficacy in vitro
resolves10.1016/j.biomaterials.2009.05.012
A surface-eroding antibiotic delivery system based on poly-(trimethylene carbonate)
resolves10.1021/ja106288c
Dual Functional Polyelectrolyte Multilayer Coatings for Implants: Permanent Microbicidal Base with Controlled Release of Therapeutic Agents
resolves10.1016/j.matlet.2014.06.070
Biodegradable Bi-layered coating on polymeric orthopaedic implants for controlled release of drugs
resolves10.1016/j.msec.2014.04.036
Characterization and antibacterial performance of electrodeposited chitosan–vancomycin composite coatings for prevention of implant-associated infections
resolves10.1016/j.jconrel.2011.09.062
Release of vancomycin from multilayer coated absorbent gelatin sponges
resolves10.1039/C3BM60203F
Digital drug delivery: on–off ultrasound controlled antibiotic release from coated matrices with negligible background leaching
resolves10.1016/j.chembiol.2005.06.013
Vancomycin Covalently Bonded to Titanium Beads Kills Staphylococcus aureus
resolves10.1002/jbm.b.30503
Biodegradable polymer–silica xerogel composite microspheres for controlled release of gentamicin
resolves10.1002/1097-4636(200111)57:2<313::AID-JBM1173>3.0.CO;2-E
Silica sol-gel for the controlled release of antibiotics. I. Synthesis, characterization, andin vitro release
resolves10.1007/s10856-009-3835-9
Silica xerogel-chitosan nano-hybrids for use as drug eluting bone replacement
resolves10.1016/j.biomaterials.2013.09.073
Sol–gel silica controlled release thin films for the inhibition of methicillin-resistant Staphylococcus aureus
resolves10.1016/j.biomaterials.2006.11.035
Controlled release of vancomycin from thin sol–gel films on titanium alloy fracture plate material
resolves10.1016/j.porgcoat.2018.01.026
Electrochemical study of the synergic effect of phosphorus and cerium additions on a sol-gel coating for Titanium manufactured by powder metallurgy
resolves10.3390/ma10020094
Biocompatibility and Corrosion Protection Behaviour of Hydroxyapatite Sol-Gel-Derived Coatings on Ti6Al4V Alloy
resolves10.1016/j.corsci.2016.06.002
Scanning electrochemical microscopy characterization of sol-gel coatings applied on AA2024-T3 substrate for corrosion protection
resolves10.1039/C5RA16785J
Effect of heat treatment of magnesium alloy substrates on corrosion resistance of a hybrid organic–inorganic sol–gel film
resolves10.1016/j.porgcoat.2014.06.004
Study of the degradation of hybrid sol–gel coatings in aqueous medium
resolves10.1016/j.jnoncrysol.2016.09.026
Control of the degradation of silica sol-gel hybrid coatings for metal implants prepared by the triple combination of alkoxysilanes
resolves10.1016/j.porgcoat.2016.01.019
Development of hybrid sol–gel coatings for the improvement of metallic biomaterials performance
resolves10.5194/jsss-6-303-2017
Electrical impedance spectroscopy (EIS) for biological analysis and food characterization: a review
resolves10.1016/j.porgcoat.2018.07.008
Evaluation of the corrosion protection performance of mild steel coated with hybrid sol-gel silane coating in 3.5 wt.% NaCl solution
resolves10.1007/s00396-011-2504-y
Preparation of sol–gel hybrid materials from γ-methacryloxypropyltrimethoxysilane and tetramethyl orthosilicate: study of the hydrolysis and condensation reactions
resolves10.1016/j.colsurfb.2019.06.042
Functionalization of sol-gel coatings with organophosphorus compounds for prosthetic devices
resolves10.1016/j.matdes.2014.04.005
Powder metallurgy CP-Ti performances: Hydride–dehydride vs. sponge
resolves10.1016/j.eimc.2016.04.003
Assessment of biofilm production in Candida isolates according to species and origin of infection
resolves10.1080/13693780701581458
Microplate Alamar blue assay for susceptibility testing of<i>Candida albicans</i>biofilms
resolves10.1302/0301-620X.100B2.BJJ-2017-0575.R1
The effect of bearing surface on risk of periprosthetic joint infection in total hip arthroplasty
resolves10.1007/s10570-019-02265-8
Hydrophobic and antibacterial textile fibres prepared by covalently attaching betulin to cellulose
resolves10.1016/j.apsusc.2017.05.257
Superhydrophobic properties induced by sol-gel routes on copper surfaces
resolves10.1007/s10973-011-1553-2
Study of the thermal degradation of bioactive sol–gel coatings for the optimization of its curing process
resolves10.1016/j.jnoncrysol.2005.03.048
NMR and IR spectroscopy of silica aerogels with different hydrophobic characteristics
resolves10.1016/S0022-328X(00)88009-2
Über die 1H-, 13C- und 29Si-NMR chemischen Verschiebungen einiger linearer, verzweigter und cyclischer Methylsiloxan-Verbindungen
resolves10.1016/j.porgcoat.2014.01.019
Polymerization of hybrid organic–inorganic materials from several silicon compounds followed by TGA/DTA, FTIR and NMR techniques
resolves10.1088/0957-4484/21/48/485703
Tribocorrosion behaviour of nanostructured titanium substrates processed by high-pressure torsion
resolves10.1016/j.electacta.2004.12.010
EIS study of corrosion behaviour of organic coating/Dacromet composite systems
resolves10.1016/j.cemconcomp.2006.01.012
EIS study of passivation of austenitic and duplex stainless steels reinforcements in simulated pore solutions
resolves10.1016/j.porgcoat.2007.08.002
Evaluation of cure temperature effects in cataphoretic automotive primers by electrochemical techniques
resolves10.1128/AAC.01480-08
Anidulafungin Is Fungicidal and Exerts a Variety of Postantifungal Effects against
<i>Candida albicans</i>
,
<i>C. glabrata</i>
,
<i>C. parapsilosis</i>
, and
<i>C. krusei</i>
isolates
The 9 references without a DOI — listed, not checked
no DOI — not checkedThe incidence and socioeconomic impact of periprosthetic joint infection: United States perspective
no DOI — not checkedNovel methods of antifungal administration
no DOI — not checkedTotal knee arthroplasty and infection: how surgeons can reduce the risks
no DOI — not checkedElectrospun vancomycin-loaded coating on titanium implants for the prevention of implant-associated infections
no DOI — not checked10.1016/j.porgcoat.2020.105681_bib0255
no DOI — not checked1 – Biomedical engineering: a historical perspective
no DOI — not checked10.1016/j.porgcoat.2020.105681_bib0355
no DOI — not checked10.1016/j.porgcoat.2020.105681_bib0400
no DOI — not checked10.1016/j.porgcoat.2020.105681_bib0410
What this badge says. CiteStamped means the CHECKABLE references of this
work were clean at the dated check: each resolved to a known work in a public registry, and none
carried a retraction notice at that time. It says nothing about the quality, findings,
or importance of the work itself, and nothing about references deposited without a DOI.
checked 2026-07-23 — re-checked daily as this page is visited; titles and statuses come from Crossref and DataCite and are not part of the signed record
Embed this badge
Both snippets point at the live badge image and link back to this page. The badge re-renders from the daily check, so an embed never goes stale by more than a day of visits.
<a href="https://citestamp.com/citestamped/10.1016/j.porgcoat.2020.105681"><img src="https://citestamp.com/citestamped/10.1016/j.porgcoat.2020.105681/badge.svg" alt="CiteStamped reference-health badge" width="460" height="64"></a>
[](https://citestamp.com/citestamped/10.1016/j.porgcoat.2020.105681)