Reference health

Investigations on the origin of mass and elastic loading in the time varying distinct response of ZnO SAW ammonia sensor

https://doi.org/10.1016/j.snb.2012.03.013
CiteStamped reference-health badge
24/24 checkable references clean · checked 2026-07-23

Every reference with a DOI in the deposited reference list resolved to a known work in Crossref or DataCite at the dated check, and none carried a retraction, withdrawal, or removal notice.

5 without a DOI — not checked. A reference deposited without a DOI is never matched by title or guessed at; it stays outside the checked set, and this line discloses that.

The 24 checked references that resolve
resolves10.1016/j.snb.2006.04.082
SAW-based gas sensors with rf sputtered InOx and PECVD SiNx films: Response to H2 and O3 gases
resolves10.1016/j.snb.2006.09.013
Fabrication of polymer SAW sensor array to classify chemical warfare agents
resolves10.1016/j.snb.2008.08.040
Development of handheld SAW vapor sensors for explosives and CW agents
resolves10.1021/ac00117a031
Dewetting Effects on Polymer-Coated Surface Acoustic Wave Vapor Sensors
resolves10.1021/cr980094j
Acoustic Wave Microsensor Arrays for Vapor Sensing
resolves10.1016/S0032-3861(03)00280-5
Thin fluoropolymer films and nanoparticle coatings from the rapid expansion of supercritical carbon dioxide solutions with electrostatic collection
resolves10.1016/j.snb.2010.01.042
New sensitive coating based on modified diamond nanoparticles for chemical SAW sensors
resolves10.1016/j.snb.2007.12.061
Surface acoustic wave gas monitor for ppm ammonia detection
resolves10.1016/j.synthmet.2007.11.008
A polyaniline/WO3 nanofiber composite-based ZnO/64° YX LiNbO3 SAW hydrogen gas sensor
resolves10.1016/j.snb.2008.06.030
Polypyrrole nanofiber surface acoustic wave gas sensors
resolves10.1016/S0925-4005(98)00163-4
Harmonic frequency analysis of SAW resonator chemical sensors: application to the detection of carbon dioxide and humidity1Research sponsored by the Laboratory Directed Research and Development Program of Oak Ridge National Laboratory, managed by Lockheed Martin Energy Research Corporation for the US Department of Energy under Contract No. DE-AC05-96OR22464.1
resolves10.1016/S0924-4247(98)80011-3
Development of a saw gas sensor for monitoring so2 gas
resolves10.1016/j.snb.2007.07.026
Metal-free phthalocyanine and palladium sensor structure with a polyethylene membrane for hydrogen detection in SAW systems
resolves10.1016/j.snb.2005.07.046
Highly sensitive layered ZnO/LiNbO3 SAW device with InOx selective layer for NO2 and H2 gas sensing
resolves10.1016/0925-4005(94)01277-O
Elastic properties of thin-film palladium for surface acoustic wave (SAW) sensors
resolves10.1063/1.1769598
Effect of substrate-induced strain on the structural, electrical, and optical properties of polycrystalline ZnO thin films
resolves10.1016/j.snb.2010.03.079
Cross-sensitivity and selectivity studies on ZnO surface acoustic wave ammonia sensor
resolves10.1063/1.2903531
Influence of stress on the structural and dielectric properties of rf magnetron sputtered zinc oxide thin film
resolves10.1557/PROC-722-K7.16
Effects of growth temperature on structural properties of ZnO thin films
resolves10.1016/j.snb.2005.05.021
A comparative analysis of one-port Colpitt and two-port Pierce SAW oscillators for DMMP vapor sensing
resolves10.1016/0040-6090(91)90399-I
Thin metal film characterization and chemical sensors: monitoring electronic conductivity, mass loading and mechanical properties with surface acoustic wave devices
resolves10.1016/S0924-4247(97)80275-0
Love wave acoustic immunosensor operating in liquid
resolves10.1109/58.896138
Dual SAW sensor technique for determining mass and modulus changes
resolves10.1016/S0039-6028(99)00260-5
Coadsorption of ammonia and electrolyte anions on a Pt(111) electrode
The 5 references without a DOI — listed, not checked
no DOI — not checked10.1016/j.snb.2012.03.013_bib0090
no DOI — not checkedZnO films deposited by RF magnetron sputtering
no DOI — not checkedInfluence of post deposition annealing on the structural and optical properties of sputtered zinc oxide film
no DOI — not checked10.1016/j.snb.2012.03.013_bib0130
no DOI — not checkedDual SAW sensor technique for determining mass and modulus changes in thin silicate films during gas adsorption
What this badge says. CiteStamped means the CHECKABLE references of this work were clean at the dated check: each resolved to a known work in a public registry, and none carried a retraction notice at that time. It says nothing about the quality, findings, or importance of the work itself, and nothing about references deposited without a DOI.

checked 2026-07-23 — re-checked daily as this page is visited; titles and statuses come from Crossref and DataCite and are not part of the signed record

Embed this badge

Both snippets point at the live badge image and link back to this page. The badge re-renders from the daily check, so an embed never goes stale by more than a day of visits.

<a href="https://citestamp.com/citestamped/10.1016/j.snb.2012.03.013"><img src="https://citestamp.com/citestamped/10.1016/j.snb.2012.03.013/badge.svg" alt="CiteStamped reference-health badge" width="460" height="64"></a>
[![CiteStamped reference-health badge](https://citestamp.com/citestamped/10.1016/j.snb.2012.03.013/badge.svg)](https://citestamp.com/citestamped/10.1016/j.snb.2012.03.013)